Feet - Compaq ProLiant 1600 Maintenance And Service Manual

2-8 Removal and Replacement Procedures

Feet

To remove the feet from the chassis, one at a time:
1. Perform the preparation procedures. See page 2-2.
2. Remove the front bezel. See page 2-6.
3. Place the server on its left side.
4. Remove the T-15 screw from each foot 1.
5. Pivot each foot down 2, and pull it off the base of the chassis 3.
3
2
1
Figure 2-3. Removing the feet from the chassis
Reverse steps 1 through 5 to replace the feet. Make sure each foot snaps securely
in its position.