Compaq ProLiant 1600 Maintenance And Service Manual page 94

DAAD Diagnostic Messages
Message
NVRAM EISA nonvolatile RAM has a
configuration configuration for an array controller
present, but there is no board in this slot.
controller not Either a board has been removed
detected from the system or a board has
been placed in the wrong slot.
Compatibility Compatibility port configured for
port problem this IDA controller. When DAAD
detected was verifying this interface, a
serious problem
was detected.
Configuration DAAD detected that nonvolatile
signature is RAM contains a configuration
zero signature that is zero. Old
versions of the System
Configuration Utility could cause
this.
Configuration Array accelerator board
signature configured for a different array
mismatch controller board. Configuration
signature on array accelerator
board does not match the one
stored on the array controller
board.
Controller Controller communication
communication failure occurred.
failure
occurred
Controller EISA nonvolatile RAM does not
detected. contain a configuration for this
NVRAM controller.
configuration
not present
Controller Controller firmware is below the
firmware latest recommended version.
needs
upgrading
Controller Controller is correct, however,
firmware IDA firmware version should be
needs greater
upgrading than 1.26.
(DAAD Error
Continued
Description
Run the latest version of System
Configuration Utility to configure the controller
and nonvolatile RAM.
To recognize the array accelerator board, run
the System Configuration Utility.
DAAD was unable to successfully issue
commands to the controller in this slot.
Run the System Configuration Utility to
configure the nonvolatile RAM.
Run Options ROMPaq to upgrade the
controller to the latest firmware revision.
Obtain the latest firmware.
Compaq ProLiant 1600 Servers Maintenance and Service Guide
Recommended Action
Place the array controller in the proper slot
or run the System Configuration Utility to
reconfigure nonvolatile RAM to reflect the
removal or new position.
A hardware problem has occurred; replace
the IDA controller.
3-49