Power Switch - Compaq ProLiant 1600 Maintenance And Service Manual

2-20 Removal and Replacement Procedures

Power Switch

To remove the power switch and cable assembly:
1. Perform the preparation procedures. See page 2-2.
2. Remove the front bezel. See page 2-6.
3. Remove the top cover. See page 2-10.
4. Remove the single T-15 screw 1.
5. Slide the power switch housing back 2 and lift it out of the chassis 3.
Figure 2-16. Removing the power switch housing
WARNING: Any surface or area of the equipment marked
with these symbols indicates the presence of electrical
shock hazards. The enclosed area contains no operator-
serviceable parts. To reduce the risk of injury from electrical
shock hazards, do not open this enclosure.
2
3
1