Compaq ProLiant 1600 Maintenance And Service Manual page 92

DAAD Diagnostic Messages
Message
Accelerator Data in the cache was lost, but not
status: Data in because of the battery being
the cache was discharged.
lost due to
some reason
other than the
battery being
discharged
Accelerator Cache board was probably
status: Cache replaced with one of a different
was size.
automatically
configured
during last
controller
reset. This can
occur when
cacheboard is
replaced with
one of a
different size.
Accelerator Valid data was found in posted
status: Valid write memory at reinitialization.
data found at Data will be flushed to disk.
reset
Accelerator Catastrophic problem with array
status: accelerator board. Refer to other
Warranty alert messages on Diagnostics screen
for exact meaning of this message.
Adapter/NVRA EISA nonvolatile RAM has an ID
M ID mismatch for a different controller from the
one physically present in the slot.
Battery pack X Battery pack on the array
below accelerator is below the required
reference voltage levels.
voltage
Battery X not Battery is not fully charged.
fully charged
Board not Array controller configured for use
Continued
Description
Compaq ProLiant 1600 Servers Maintenance and Service Guide
Recommended Action
Check to be sure that the array accelerator
is properly seated. If the error continues
you may need to replace the array
accelerator.
Nothing needs to be done. Normal
operations should continue.
Not an error or data loss condition. No
action needs to be taken.
Replace the array accelerator board.
Run the System Configuration Utility.
Allow enough time for batteries to recharge
(36 hours). If batteries have not recharged
after 36 hours, replace the array accelerator
board.
If 75% of the batteries present are fully
charged, the array accelerator is fully
operational. If more than 75% of the
batteries are not fully charged, allow 36
hours to recharge them.
Attach array accelerator board to array
3-47