Right Side Access Panel - Compaq ProLiant 1600 Maintenance And Service Manual

2-11

Right Side Access Panel

Remove the right side access panel to convert from tower to rack or to replace a damaged
panel. To remove the right side access panel:
1. Perform the preparation procedures. See page 2-2.
2. Remove the front bezel. See page 2-6.
3. Remove the feet on the base of the right side access panel (tower model). See page 2-8.
4. Remove the two T-15 screws securing the right side access panel to the front of the
chassis.
5. Pull the right side access panel back and away from the chassis.
Figure 2-6. Removing the right side access panel
Reverse steps 1 through 5 to replace the right side access panel.
Compaq ProLiant 1600 Servers Maintenance and Service Guide