Removal And Replacement Procedures; Electrostatic Discharge Information - Compaq ProLiant 1600 Maintenance And Service Manual

Chapter 2
Removal and Replacement
Procedures
This chapter provides subassembly/module-level removal and replacement procedures for the
ProLiant 1600 Servers Supporting Pentium II Processors with 100 MHz GTL Bus. After
completing all necessary removal and replacement procedures, run the Diagnostics program to
verify that all components operate properly.
To service Compaq ProLiant 1600 Servers, you might need the following:
Torx T-15 screwdriver
From the Compaq SmartStart and Support Software CD:
System Configuration Utility software
Drive Array Advanced Diagnostics software
Diagnostics software

Electrostatic Discharge Information

A discharge of static electricity can damage static-sensitive devices or microcircuitry. Proper
packaging and grounding techniques are necessary precautions to prevent damage. To prevent
electrostatic damage, observe the following precautions:
Transport products in static-safe containers such as conductive tubes, bags, or boxes.
Keep electrostatic-sensitive parts in their containers until they arrive at static-free
stations.
Cover work stations with approved static-dissipating material. Provide a wrist strap
connected to the work surface and properly grounded tools and equipment.
Keep work area free of non-conductive materials such as ordinary plastic assembly aids
and foam packing.
Make sure you are always properly grounded when touching a static-sensitive
component or assembly.
Avoid touching pins, leads, or circuitry.
Always place drives PCB assembly side down.
Use conductive field service tools.
Compaq ProLiant 1600 Servers Maintenance and Service Guide
2-1