Compaq ProLiant 1600 Maintenance And Service Manual page 41

2-28 Removal and Replacement Procedures
The following guidelines MUST be followed when installing or replacing memory:
Use 100 MHz, 32-, 64-,128-, or 256-MB; registered SDRAM DIMMs.
To remove a SDRAM DIMM:
1. Perform the preparation procedures. See page 2-2.
2. Remove the processor cage and place it on a non-conductive work surface. See page 2-
22. Open the cage door.
3. Locate the appropriate memory socket on the processor board.
4. Push the levers on each end of the memory module 1.
5. Pull the module from the board 2.
Figure 2-24. Removing a SDRAM DIMM from the processor board
Reverse steps 1 through 5 to replace the SDRAM DIMM. This memory module can be
installed in one way only. Match the notch on the module with the tab on the memory socket.
Push the module down into the socket, making sure that the module is inserted fully and
seated properly.
CAUTION: Use only Compaq SDRAM DIMMs. SDRAM DIMMs
from other sources may adversely affect data integrity. Power-On
Self-Test (POST) will warn of non-supported SDRAM DIMMs.
1
2
1