System I/O Board Cage - Compaq ProLiant 1600 Maintenance And Service Manual

2-18 Removal and Replacement Procedures

System I/O Board Cage

The system I/O board cage contains the system I/O board with PCI slots, system switches, ISA
slots, and the battery. Four slots are PCI/ISA; two are PCI only, for a total of six slots.
To remove the system I/O board cage:
1. Perform the preparation procedures. See page 2-2.
2. Remove the top cover. See page 2-10.
3. Disconnect all cables from the system I/O board cage and any installed boards.
4. Remove any installed boards. Place them on a non-conductive work surface. You will
install them in the replacement system I/O board cage.
NOTE: Replace the boards into the same slots from which they were removed
in the system I/O board cage.
5. Remove the security screw (if installed) 1.
6. Push down on the cage ejector lever 2, and pull out 3.
7. Pull the system I/O board cage out the back of the chassis 4.
Figure 2-14. Removing the system I/O board cage
Reverse steps 1 through 7 to replace the system I/O board cage. Install any boards removed in
step 4 in the replacement system I/O board cage.
NOTE: Replace the boards into the same slots from which they were removed
in the system I/O board cage.
2
3
4
1