5.11 Power Supply
The system must be powered down and the power cord disconnected from the power supply ac
input receptacle before performing the power supply removal and replacement procedures.
Perform the following procedure to remove the power supply:
1. At the rear of the chassis, loosen the four captive screws
to the chassis (see Figure 5-10).
2. Grasp the two handles
until the tabs
Figure 5-10).
3. Lift the power supply and remove it from the chassis.
To replace the power supply, refer to Figure 5-10 and reverse steps 1 through 3 of the removal
procedure.
Figure 5-10 Removing and Replacing the Power Supply
on the power supply and pull the power supply out of the chassis
on the power supply fall into the notches
5
4
Compaq ES40CSLP Rackmount System Installation/User/Service Guide 5–13
Removal and Replacement
c
that secure the power supply
on the support bracket (see
1
2
3
EA-00085