Compaq ProLiant 1600 Maintenance And Service Manual page 98

DAAD Diagnostic Messages
Message
Drive The monitor and performance
Monitoring is features have not been enabled.
NOT enabled
for drive bay X
Drive time-out DAAD issued a command to a
occurred on physical drive and the command
physical drive was never acknowledged.
bay X
Drive (bay) X Firmware on this physical drive
firmware is below the latest
needs recommended version.
upgrading
Drive (bay) X Physical drive has invalid
has invalid monitor and performance data.
M&P stamp
Drive X Message indicates which
indicates physical drive appears to be
position Y scrambled or in a drive bay other
than the one for which it was
originally configured.
Drive (bay) X The copies of the RIS on this
RIS copy drive do not match.
mismatch
Drive (bay) X An error occurred while DAAD
upload code was trying to read the upload
not readable code information from this drive.
Duplicate write Data could not be written to the
memory error array accelerator board in
duplicate due to the detection of
parity errors. This is not a data
loss situation.
Error occurred An error occurred while DAAD
reading RIS was trying to read the RIS from
copy from this drive.
drive (bay) X
FYI: Drive The installed drive was not
(bay) X is non- supplied by Compaq.
Compaq
supplied
Continued
Description
Run the System Configuration Utility to
initialize the monitor and performance
features.
The drive or cable may be bad. Check the
other error messages on the Diagnostics
screen to determine resolution.
Run the Options ROMPaq Utility to upgrade
the drive firmware to the latest revision.
Run the System Configuration Utility to
properly initialize this drive.
Examine the graphical drive representation on
DAAD to determine proper drive locations.
Remove drive X and place it in drive position
Y. Rearrange the drives according to the
DAAD instructions.
This drive may need to be replaced. Check for
other errors.
If there were multiple errors, this drive may
need to
be replaced.
Replace the array accelerator board.
If there were multiple errors, this drive may
need to
be replaced.
If problems exist with this drive, replace it with
a
Compaq drive.
Compaq ProLiant 1600 Servers Maintenance and Service Guide
Recommended Action
3-53
Continued