Multi-Purpose Tray Pick Roller - Tektronix PHASER 560 Service Manual

8
FRU Disassembly/Assembly

Multi-purpose tray pick roller

8-8 Phaser 560 Color Printer
Downloaded from www.Manualslib.com
Required tools
Small, flatblade screwdriver
The multi-purpose pick roller should be replaced whenever the cork separator
pad is replaced. The expected life of each is about 30k prints.
1. Turn off the printer.
2. Open the left side door to access the paper feeder. Slide out the paper
feeder.
3.
With a small, narrow, flat-blade screwdriver, carefully release the
snap-fit cover over the multi-purpose tray pick roller. Small access
holes allow you to access the five retaining latches.
4. Slide the right-end pick roller retainer on its shaft about 75 mm (3 in.)
towards the front of the printer. You may need to use a small
flat-blade screw driver to release the retainers hook from the groove in
the shaft it locks into.
manuals search engine
Phillips #2