7510-XXX
Clamp paddle removal
1. Remove the finisher front door assembly. See
"Finisher front door assembly removal" on page
4-26.
2. Remove the rear upper cover. See
"Rear upper cover removal" on page
4-23.
3. Remove the media eject shaft assembly. See
"Media eject shaft assembly removal" on page
4-73.
4. Remove the three clamp paddles (A) by sliding them out of the media eject shaft assembly (B).
B
A
Narrow
Wide
A
Right
Replacement note: Replacement is easier if you lightly moisten the rubber surface of the paddles with water.
4-75
Repair information