Clamp Paddle Removal - Lexmark X95x series Service Manual

7558-xxx
Disconnect the connector from the media eject clamp motor (C).
4.
5. Disconnect the connector from the sensor (media eject clamp HP) (D).
Remove the three screws securing the bracket (E) to the finisher.
6.
7. Remove the bracket (E).
Note: When removing the bracket, turn the media eject clamp gear 70T (F) so that it does not interact with
the sensor (media eject clamp HP) (D).
Rear
Remove the two screws securing the media eject clamp motor to the bracket (E).
8.
Remove the media eject clamp motor (C).
9.
Reinstallation note: When replacing the bracket, turn the media eject clamp gear 70T (F) so that it interacts
with the sensor (media eject clamp HP).

Clamp paddle removal

Remove the finisher front door assembly. See
1.
Remove the rear upper cover. See
2.
Remove the media eject shaft assembly. See
3.
Service Manual
4-338
F
"Finisher front door assembly removal" on page
"Rear upper cover removal" on page
"Eject roll shaft removal" on page
Connector
D
4-377.
4-339.
Previous
Next
Go Back
E
C
4-345.