Upper Media Exit Roll Assembly Removal - Lexmark X940e Service Manual

Upper media exit roll assembly removal

1. Open the finisher front door assembly.
2. Remove the rear upper cover. See
3. Remove the upper media bin assembly. See
4. Remove the top cover. See
5. Remove the drive motor (exit). See
6. Disconnect the connector from the sensor (upper media exit) (A).
7. Release the harness from the clamps.
8. Remove the two front and two rear screws securing the upper exit guide assembly (B).
9. Remove the upper exit guide assembly.
10. Remove the two front screws and the two rear screws securing the bracket (C) to the finisher.
Front
"Rear upper cover removal" on page
"Upper media bin assembly removal" on page
"Top cover removal" on page
"Drive motor (exit) assembly and belt (exit) removal" on page
4-23.
4-18.
A
Connector
Left
Rear
Repair information
7510-XXX
4-19.
4-110.
4-103