Rear Tamping - Lexmark X940e Service Manual

Rear tamping

Rear tamping is used in the following cases.
• When executing rear stapling (corner)
• When executing dual stapling
The tamper positions during rear tamping are shown below.
Sensor (front tamper HP)
Front
Front tamper motor
Position Description
1 Front tamper home position–sensor (front tamper HP)
2 Front tamper tamping position
3 Front tamper offset position
4 Rear tamper home position–sensor (rear tamper HP)
5 Rear tamper size position
6 Rear tamper offset position
Front tamper Rear tamper
Sensor (rear tamper HP)
Rear
Rear tamper motor
General information
7510-XXX
1-19