Sensor (Buffer Path) Late Jam - Lexmark X940e Service Manual

Step Check
4 Check the drive motor (entrance/paddle) for proper
connection.
Is the above component properly connected?
5
Perform a print test.
Does the error remain?

283.00 Sensor (buffer path) late jam

Step Check
1 Check the finisher media entrance roll assembly.
Is the above component free of excess wear and
contamination?
2 Check the finisher buffer roll assembly.
Is the above component free of excess wear and
contamination?
3 Check the sensor (diverter gate) for proper operation.
1. Enter the Diagnostics Menu.
2. Touch FINISHER TESTS.
3. Touch Sensor Test.
4. Touch Media Path 2.
5. Touch Diverter gate.
Does the display on the operator panel change every
time the sensing area of the above sensor is
interrupted or blocked?
Yes No
Replace the drive Replace the
motor (entrance/ connection.
paddle).
Go to "Drive
motor
(entrance/
paddle) and belt
(entrance/
paddle)
removal" on
page 4-98.
Replace the Problem solved.
finisher controller
card assembly.
Go to "Finisher
controller card
assembly
removal" on
page 4-115.
Yes No
Go to step 2. Clean or replace
the finisher
media entrance
roll assembly.
Go to
media entrance
roll assembly
removal" on
page
Go to step 3. Clean or replace
the finisher buffer
roll assembly.
Go to
buffer roll
assembly
removal" on
page
Go to step 5. Go to step 4.
Diagnostic information
7510-XXX
"Finisher
4-97.
"Finisher
4-92.
2-23