Front Tamping - Lexmark X940e Service Manual

7510-XXX

Front tamping

Front tamping is used in the following cases.
• In the non-staple mode
• When executing front stapling (corner)
The tamper positions during front tamping are shown below.
Sensor (front tamper HP)
Front tamper motor
Position Description
1 Front tamper home position–sensor (front tamper HP)
2 Front tamper size position
3 Front tamper offset position
4 Rear tamper home position–sensor (rear tamper HP)
5 Rear tamper standby position
6 Rear tamper tamping position
7 Rear tamper offset position
1-18
MFP Finisher Service Manual
Front
Front tamper
Sensor (rear tamper HP)
Rear
Rear tamper
Rear tamper motor