Require Standby; Short Edge Printing; Tray Low Message; Les Applications - Lexmark X940e Service Manual

Require Standby

This setting determines if the Standby Mode is On or Off. The default is On.
To change this setting:
1. Touch Require Standby from the Configuration Menu.
2. Touch Back to cancel and return to the Configuration Menu.
3. Touch Submit to save the change.
If Standby Mode is on, the printer begins functioning in Standby Mode when it remains idle for an amount of
time. The Standby Mode enables the printer:
•
To consume less energy than when operating in normal mode but not as little as when operating in Power
Saver
•
To return to the Ready state more quickly than when operating in Power Saver

Short Edge Printing

The default printing orientation is long edge. This setting allows you to enable or prohibit short edge fed paper. If
the setting Disabled (default) is selected, letter and A4 paper can only be fed long edge. If they are fed short
edge, a prompt will ask you to use the correct paper size. When the setting is Enabled, you can feed paper
either long edge or short edge.
To change this setting:
1. Touch Short Edge Printing from the Configuration Menu.
2. Touch Back to cancel and return to the Configuration Menu.
3. Touch Submit to save the change.

Tray Low Message

This setting allows you to disable any Tray Low warnings that the printer may register.
Touching Disabled turns off the tray low prompts. The default is Enabled.
To change this setting:
1. Touch Require Standby from the Configuration Menu.
2. Touch Back to cancel and return to the Configuration Menu.
3. Touch Submit to save the change.

LES Applications

This disables all installed Lexmark Embedded Solution applications. The default is Enabled.
To change this setting:
1. Touch LES Applications from the Configuration Menu.
Note: If an advanced password has been established, you must enter this password in order to change the
setting. If no advanced password exists, you can establish one by using the keyboard that appears on the LCD.
2. Touch Back to cancel and return to the Configuration Menu.
3. Touch Submit to save the change.
7510-XXX
3-49
Diagnostic aids