7510-XXX
Sensor (finisher media entrance) removal
1. Open the front door assembly.
2. Remove the rear upper cover. See
3. Remove the upper media bin assembly. See
4. Remove the top cover. See
5. Remove the left lower cover. See
6. Remove the left upper cover. See
7. Disconnect the connector from the sensor (finisher media entrance) (A).
8. Release the harness from the clamp.
9. Remove the screw securing the bracket (B) to the media entrance pinch guide assembly (C).
Connector
10.Release the hooks securing the sensor (finisher media entrance) (A) to the bracket (B).
11. Remove the sensor (finisher media entrance) (A).
4-96
MFP Finisher Service Manual
"Rear upper cover removal" on page
"Upper media bin assembly removal" on page
"Top cover removal" on page
"Left lower cover removal" on page
"Left upper cover removal" on page
A
Clamp
Left
4-23.
4-18.
4-27.
4-28.
B
C
4-19.