Image transfer unit (ITU) removal
Write down the number on the new ITU before installing it. You will need the 16-digit numeric value from
1.
the barcode after the installation, and it is easier to see at this point.
Remove the right cover. See
2.
Remove the rear shield. See
3.
Remove the waste toner bottle. See
4.
5.
Remove the imaging unit (IU). See
Note: The ITU FRU includes a spring clamp kit. If the printer does not have this kit installed, perform the
following steps to prepare for the later installation. Continue below with
kit removal" on page
(with or without spring clamp kit)" on page
ITU without spring clamp kit removal
Pull the gear (A) straight out to unsnap it, and then discard it. A new gear is included in the spring clamp kit
1.
and must be used with the new spring clamp.
"Right cover removal" on page
"Rear shield removal" on page
"Waste toner bottle removal" on page
"Imaging unit (IU) removal" on page
4-43. If the spring clamp kit is not installed, skip to
4-45.
4-7.
4-7.
4-73.
4-63.
"ITU without spring clamp
"Continuing the removal
Repair information
7525-63x
Previous
Next
Go Back
4-43