Sensor (Punch Unit Motor Encoder) Removal - Lexmark X940e Service Manual

7510-XXX

Sensor (punch unit motor encoder) removal

1. Open the finisher front door assembly.
2. Remove the rear upper cover. See "Rear upper cover removal" on page 4-23.
3. Remove the upper media bin assembly. See "Upper media bin assembly removal" on page 4-19.
4. Remove the top cover. See "Top cover removal" on page 4-18.
5. Remove the punch carriage assembly. See "Punch carriage assembly removal" on page 4-40.
6. Disconnect the connector from the punch unit motor assembly (A).
7. Disconnect the connector from the sensor (punch unit motor encoder) (B).
8. Remove the harness from the clamp.
9. Remove the two screws securing the bracket (C) to the punch unit assembly (D).
B
B
A
C
Clamp
Connector
D
10.Release the hooks securing the sensor (punch unit motor encoder) (B) to the bracket (C).
11.Remove the sensor (punch unit motor encoder) (B).
4-47
Repair information