Sensor (Diverter Gate) Removal - Lexmark X940e Service Manual

Sensor (diverter gate) removal

1. Open the finisher front door assembly.
2. Remove the rear upper cover. See
3. Remove the upper media bin assembly. See
4. Remove the top cover. See
5. Remove the left lower cover. See
6. Remove the left upper cover. See
7. Remove the punch carriage assembly. See
8. Remove the two screws securing the bracket (A) to the finisher.
9. Remove the bracket (A).
10. Disconnect the connector from the sensor (diverter gate) (B).
11. Remove the screw securing the sensor (diverter gate) (B) to the bracket (A).
12. Remove the sensor (diverter gate) (B).
"Rear upper cover removal" on page
"Top cover removal" on page
"Left lower cover removal" on page
"Left upper cover removal" on page
A
Connector
B
"Upper media bin assembly removal" on page
4-18.
"Punch carriage assembly removal" on page
4-23.
4-19.
4-27.
4-28.
4-40.
Left
Repair information
7510-XXX
4-107