Lexmark X940e Service Manual page 331

6. Disconnect the connector from the drive motor (buffer/transport).
7. Remove the two screws securing the bracket (E) to the finisher.
8. Remove the bracket.
9. Remove the two screws securing the drive motor (buffer/transport) to the bracket.
10. Remove the drive motor (buffer/transport).
11. Remove the belt (buffer/transport) (D).
Replacement notes:
•
The tension of the belt (buffer/transport) (D) is automatically adjusted by the force of the spring attached to
the belt tensioner bracket (C).
•
Tighten the two screws in the order shown.
Connector
7510-XXX
E
B
Repair information
4-113