Sensor (Bridge Exit Bin) Lag Jam - Lexmark X940e Service Manual

Step
8 Check the bridge unit drive motor for proper operation.
1. Enter the Diagnostics Menu.
2. Touch MOTOR TESTS.
3. Touch Finisher Motor Tests.
4. Touch Bridge unit drive motor.
Does the above component operate properly?
9 Check the bridge unit drive motor for proper connection.
Is the above component properly connected?
10 Perform a print test.
Does the error continue?
11
Perform a print test.
Does the error continue?

281.05 Sensor (bridge exit bin) lag jam

Step
1 Check the media position.
Does the media touch the sensor (bridge unit bin exit)?
2 Check the sensor (bridge unit media bin exit) for proper
operation.
1. Enter the Diagnostics Menu.
2. Touch FINISHER TESTS.
3. Touch Sensor test.
4. Touch Media Path 1.
5. Touch Bridge unit media bin exit.
Does the display on the operator panel change every time
the sensing area of the above sensor is interrupted or
blocked?
Check
Caution: When performing motor tests,
ensure that all cover and door interlock
switches are overridden.
Check
Yes
Go to step 10. Go to step 9.
Replace the bridge Replace the
unit drive motor. connection.
Go to "Bridge
unit drive motor
removal" on
page 4-8.
Replace the bridge Problem solved.
unit interface card
assembly.
Go to "Bridge
unit interface
card assembly
removal" on
page 4-114.
Go to step 11.
Replace the Problem solved.
finisher controller
card assembly.
Go to "Finisher
controller card
assembly
removal" on
page 4-115.
Yes
Remove the Go to step 2.
media.
Go to step 4. Go to step 3.
Diagnostic information
7510-XXX
No
No
2-17