7510-XXX
Punch unit motor assembly removal
1. Open the finisher front door assembly.
2. Remove the rear upper cover. See
3. Remove the upper media bin assembly. See
4. Remove the connector from the sensor (punch carriage shift HP) (A).
5. Remove the top cover. See
6. Remove the punch carriage assembly. See
7. Disconnect the connector from the punch unit motor assembly (A).
8. Disconnect the connector from the sensor (punch unit motor encoder) (B).
9. Remove the harness from the clamp.
10. Remove the two screws securing the punch unit motor assembly (A) to the punch unit assembly (C).
Connector
11. Remove the punch unit motor assembly.
4-46
MFP Finisher Service Manual
"Rear upper cover removal" on page
"Upper media bin assembly removal" on page
"Top cover removal" on page
"Punch carriage assembly removal" on page
Clamp
4-23.
4-18.
B
A
C
4-19.
4-40.