4024-110
Clamp paddle removal
1.
Remove the finisher front door assembly. See
2.
Remove the rear upper cover. See
3.
Remove the media eject shaft assembly. See
4.
Remove the three clamp paddles (A) by sliding them out of the media eject shaft assembly (B).
Replacement note: Replacement is easier if you lightly moisten the rubber surface of the paddles with water.
4-76
Finisher Service Manual
"Finisher front door assembly removal" on page
"Rear upper cover removal" on page
"Media eject shaft assembly removal" on page
B
A
Right
4-24.
4-74.
A
Narrow
Wide
4-27.