7510-XXX
Step
9
Perform a print test.
Does the error remain?
289.02 sensor (booklet unit media entrance) static jam
Step
1
Check the booklet unit interface connector assembly.
Is the above component free of damage?
2
Check the main connector on the booklet unit sensor
interface cable assembly.
Is the above component free of damage?
3
Check the sensor (booklet unit media entrance) for proper
operation.
1. Enter the Diagnostics Menu.
2. Touch FINISHER TESTS.
3. Touch Sensor Test.
4. Touch Booklet path.
5. Touch Booklet unit media entrance
Does the display on the operator panel change every time
the sensing area of the above sensor is interrupted or
blocked?
4
Check the sensor (booklet unit media entrance) for proper
connection.
Is the above component properly connected?
5
Perform a print test.
Does the error remain?
2-46
MFP Finisher Service Manual
Check
Check
Yes
Replace the
Problem solved.
finisher controller
card assembly.
Go to
"Finisher
controller card
assembly
removal" on
page
4-115.
Yes
Go to step 2.
Replace the
booklet unit
interface
connector
assembly.
Go to step 3.
Replace the
booklet unit sensor
interface cable
assembly.
Go to step 5.
Go to step 4.
Replace the
Replace the
sensor (booklet
connection.
unit media
entrance).
Go to
"Sensor
(booklet unit
media entrance)
removal" on
page
4-137.
Replace the
Problem solved.
booklet controller
card assembly.
Go to
"Booklet
controller card
assembly
removal" on
page
4-119.
Go to step 6.
No
No