7510-XXX
Sensor (lower media exit) removal
1. Open the finisher front door assembly.
2. Remove the upper media bin assembly. See
"Upper media bin assembly removal" on page
4-19.
3. Disconnect the connector from the sensor (lower media exit) (A).
4. Remove the harness from the clamps.
5. Remove the two screws securing the bracket (B) to the finisher.
Clamp
Connector
Front
A
B
Note: The upper media bin vertical cover (C) has slots that make access to the screws easier, as shown.
C
Right
Access slots
B
A
6. Remove the bracket (B).
7. Release the hooks securing the sensor (lower media exit) (A) to the bracket.
8. Remove the sensor (lower media exit) (A).
4-79
Repair information