Paddle And Roll Exit Assembly Removal - Lexmark X940e Service Manual

7510-XXX

Paddle and roll exit assembly removal

1. Remove the finisher front door assembly. See
2. Remove the rear upper cover. See
3. Remove the rear lower cover. See
4. Remove the upper media bin assembly.
5. Remove the upper media bin vertical cover. See
6. Remove the stapler unit frame. See
7. Remove the media eject clamp motor assembly.
page 4-65.
8. Remove the media eject unit assembly. See
9. Remove the media compiler unit assembly. See
10. Remove the media eject motor assembly. See
11. Remove the media eject shaft assembly. See
12. Loosen the two screws securing the belt tensioner bracket (A) to the finisher, and move it down, as shown.
Replacement note: When replacing the belt tensioner bracket (A), tighten the screws in the order shown.
13. Remove the belt (exit) (B) from the lower exit roll drive pulley 20T (C).
Second
4-84
MFP Finisher Service Manual
"Finisher front door assembly removal" on page
"Rear upper cover removal" on page
"Rear lower cover removal" on page
See"Upper media bin assembly removal" on page
"Stapler unit frame removal" on page
"Media eject unit assembly removal" on page
"Media compiler unit assembly removal" on page
"Media eject motor assembly removal" on page
"Media eject shaft assembly removal" on page
B
A
O
A
C
First
4-22.
"Right eject cover removal" on page
See"Media eject clamp motor assembly removal" on
4-26.
4-23.
4-19.
4-20.
4-53.
4-58.
4-77.
4-73.
Rear
4-68.