7510-XXX
Step
Check
3
Is the sensor (stapler carriage HP) properly
connected?
Is the above component properly connected?
4
Check the stapler carriage motor assembly for proper
operation.
1. Enter the Diagnostics Menu.
2. Touch MOTOR TESTS.
3. Touch Finisher Tests.
4. Touch Stapler carriage mtr.
5. Touch Forward or Reverse.
Does the above component operate properly?
5
Is the stapler carriage motor assembly properly
connected?
Is the above component properly connected?
6
Perform a POR.
Does the error continue when the power is turned off/
on?
990.01 Sensor (stapler carriage HP) lag error
Step
Check
1
Check the stapler by moving it manually.
Does the above component slide back and forth
properly?
2-76
MFP Finisher Service Manual
Caution: When performing motor tests,
ensure that all cover and door interlock
switches are overridden.
Yes
No
Replace the
Replace the
sensor (stapler
connection.
carriage HP).
Go to
"Sensor
(stapler carriage
HP) removal" on
page
4-57.
Go to step 6.
Go to step 5.
Replace the
Replace the
stapler carriage
connection
motor assembly.
Replace the
Problem solved.
finisher controller
card assembly.
Go to
"Finisher
controller card
assembly
removal" on
page
4-115.
Yes
No
Go to step 2.
Remove
obstructions.