Media Eject Clamp Motor Assembly Removal - Lexmark X940e Service Manual

Media eject clamp motor assembly removal

1. Remove the rear upper cover. See
2. Remove the upper media bin assembly. See
3. Remove the two media eject unit springs (A) attached to the media eject unit assembly (B) by pushing them
downward.
4. Disconnect the connector from the media eject clamp motor (C).
5. Disconnect the connector from the sensor (media eject clamp HP) (D).
6. Remove the three screws securing the bracket (E) to the finisher.
7. Remove the bracket (E).
Note: When removing the bracket, turn the media eject clamp gear 70T (F) so that it does not interact with
the sensor (media eject clamp HP) (D).
Rear
8. Remove the two screws securing the media eject clamp motor to the bracket (E).
9. Remove the media eject clamp motor (C).
Replacement note: When replacing the bracket, turn the media eject clamp gear 70T (F) so that it interacts
with the sensor (media eject clamp HP).
"Rear upper cover removal" on page
"Upper media bin assembly removal" on page
Right
A
4-23.
B
F
D
Repair information
7510-XXX
4-19.
E
C
Connector
4-65