Sensor (Booklet Unit Interlock) Removal; Booklet Controller Card Assembly Removal - Lexmark X940e Service Manual

Sensor (booklet unit interlock) removal

1. Open the finisher front door assembly.
2. Pull the booklet unit assembly out of the finisher.
3. Remove rear lower cover. See
4. Disconnect the connector from the sensor (booklet unit interlock).
5. Remove sensor (booklet unit interlock) (A).

Booklet controller card assembly removal

1. Remove the rear lower cover.
2. Loosen the four screws securing the plate to the finisher.
3. Move the plate to the right and outward.
4. Remove the plate.
5. Disconnect the connectors from the booklet controller card assembly (A).
6. Remove the four screws securing the booklet controller card assembly (A).
"Rear lower cover removal" on page
Rear
"Rear lower cover removal" on page
4-22.
A
Connector
4-22.
Repair information
7510-XXX
4-119