Table of Contents
Advertisement
CDM-625 Advanced Satellite Modem
Ethernet Management
6.5.4.5.2.2 ODU | Config Page (KST-2000A/B)
Figure 6-19 shows the 'ODU | Config' page with the KST-2000A/B configured as the ODU. The
user can use this page to configure the primary Transmit and Receive Parameters of a KST-
2000A/B ODU.
Up Converter Parameters
•
Frequency: Enter a value in MHz
•
Attenuation: Enter a value in dB
•
Output: From the dropdown, select On or Off
Down Converter Parameters
•
Frequency: Enter a value in MHz
•
Attenuation: Enter a value in dB
•
Rx Band (For KST-2000B Only): From the dropdown, select band A (10950 to 11700
MHz), band B (11700 to 12200 MHz), or band C (12250 to 12750 MHz).
HPA Parameters
•
HPA Power Enable: From the dropdown, select On or Off
•
HPA Fault Logic: From the dropdown, select Summary or No Summary
LNA Parameters
•
LNA Power Enable: From the dropdown, select On or Off
•
LNA Fault Logic: From the dropdown, select Summary or No Summary
Figure 6-19. ODU | Config page (KST-2000A/B)
MN-0000036 (Ref MN/CDM625.IOM)
6–28
Revision 1
Advertisement
Table of Contents
