Disassembly Of The Ir Unit; Removal Of The Scanner Motor - Minolta CF2002 Service Manual

2-4.

Disassembly of the IR Unit

(1)

Removal of the Scanner Motor

screw
1. Remove the IR Rear Cover.
2. Remove 11 screws and the reinforcement frame.
4025D033AA
3. Remove the tension spring for the Scanner Motor
timing belt.
4025D034AA
4. Remove three screws and the Scanner Motor
Assy.
4025D036AA
5. Remove two screws and the Scanner Motor.
4025D037AA
<Reinstallation of the Scanner Motor Assy>
1. Temporarily secure the Scanner Motor Assy
using three screws.
2. Hook the spring.
3. With the Scanner drive gear set screw located on
the right-hand side as shown on the left, slide the
Scanner Motor Assy to the left and check that it is
returned to the original position by the tension of
the spring. Perform this step three times.
4. Securely tighten the three screws to fix the Scan-
ner Motor Assy into position.
4025D132AA
D-19