Minolta CF2002 Service Manual page 50

Reinstallation Procedure
NOTE
• When installing the Transfer Belt Unit, use care not to touch the Transfer Film with hands.
(Fingerprints on the Transfer Film result in image problems.)
Side Seals
Brush
1. Insert the Transfer Belt Unit halfway up to the
point shown on the left.
NOTES
• Note the arrow label provided at the guide on the
Terminal
copier side when inserting the Transfer Belt Unit.
• Insert the Transfer Belt Unit until its terminal is
stopped at the cutout in the guide on the copier
4025E027AB side.
2. Supporting the Transfer Cleaner Assy with a
hand, remove two screws.
3. Remove the Transfer Cleaner Assy.
4. Remove protective paper taped to the Transfer
Cleaner Assy.
4025E028AA
5. Turn over the Transfer Cleaner Assy so that the
brush faces upward.
Brush
4025E029AA
6. Uniformly apply the enclosed toner along the
brush and on the side seals.
NOTE
• Save a small amount of toner for use in the subse-
quent step.
• Apply toner directly to the top of the side seals.
Otherwise, the side seals could be worn or a noise
could be produced when the image transfer belt
moves.
4025E030AA
E-20