Minolta CF2002 Service Manual page 131

6. Press the Start key.
This starts the data rewriting sequence. (At this time, the Start key starts blinking red.)


Three types at once
MSC
IR
PRT
7. Check that the Touch Panel shows the message indicating that the data has been
rewritten correctly ("Downloading Completed"). Check also the Check Sum value
("Check Sum XXXX") shown on the Touch Panel. (The Start key blinks green.)
8. Unplug the power cord from the power outlet.
NOTE
• Do not turn OFF the Power Switch.
9. Remove the memory card from the slot
10. Turn OFF the Power Switch.
• Plug the copier back in and renumber the rest of the steps.
11. Turn ON the Power Switch.
12. Call the Tech. Rep. mode to the screen.
13. Select ROM Version.
14. Check that the ROM version matches the version marked on the memory card.
Action When Data Transfer Fails


If "NG" appears on the Touch Panel, indicating that rewriting has been unsuccessful (in
which case the Start key lights up red), take the following steps.
1. Perform the data rewriting procedure again.
2. If the procedure is abnormally terminated, change the memory card for a new one and
try another rewriting sequence.
3. If the procedure is still abnormally terminated, change the board that has caused "NG"
and carry out data rewriting procedure.
MSC Image Control Board PWB-F
IR Image Processing Board PWB-C
PRT
Time Required for Rewriting
approx. 20 min.
approx. 1 min. 30 sec.
approx. 6 min.
approx. 18 min. 30 sec.
PIC Board PWB-PIC
D-73