Minolta CF2002 Service Manual page 54

Reinstallation Procedure
protective tape
C4587U013AA
protective sheet
NOTE
• When installing the Imaging Unit, ensure that the color of the mounting guide of the
Imaging Unit is the same as the color of the label at the mounting position on the main
unit.
1. Remove the Imaging Unit from its aluminum
pack.
2. Tilt the Imaging Unit to the left and shake it a
small stroke in the tilt direction twice. Then, tilt it
to the right and shake it a small stroke in the tilt
direction twice.
NOTES
4025U024AA • Since the Imaging Unit is highly susceptible to
light, keep it shielded from light up to the time it is
installed.
• Carefully unseal the aluminum pack.
• If the Imaging Unit is packed in the aluminum pack-
age again, seal the package using tape or another
means.
3. Remove the protective tapes
4. Remove the shipping cushion.
CAUTION
• Make sure that the protective sheet is rolled up into
the Imaging Unit as shown in the <OK>.
<OK>
protective
sheet
C4587U015AA
5. Keeping the Imaging Unit in a level position,
insert the Imaging Unit into the mounting position
all the way until it is stopped.
NOTE
• Do not allow the Imaging Unit to become tilted
while installing them into the Main Unit, as damage
to the PC Drum or the LED assembly can result.
4025U028AC
E-24
<NG>