17. Select "Cyan," "SINGLE," and "HYPER."
18. Press the Clear key to clear the density setting.
19. Enter "255" from the 10-Key Pad.
20. Press the Start key to let the copier produce a test pattern.
21. Check to see if the image on the leading and trailing edges of the test pattern is faint.
If the image is faint:
22. Touch these keys in this order: "Machine Adjust" → "PRT Area" → "Top Margin."
23. Touch "2nd Transfer Timing" and then use the Down key to decrease the setting.
NOTE
• Decreasing the setting makes transfer timing faster. An abnormally low setting could,
however, result in a paper misfeed.
24. Touch "END."
25. Produce a halftone test pattern again.
26. Check the image on the leading and trailing edges of the test pattern.
27. If the image on the leading and trailing edges of the test pattern is faint, change the set-
ting and make a check again.
D-47