Minolta CF2002 Service Manual page 51

11. Holding onto both ends of the Transfer Belt, rotate the Transfer Belt one complete Rota-
tion in the Same direction as in step 8, and check the Blade for improper contact, or fail-
ure to remove the toner completely, or for any noise or binding.
NOTES
• If any faulty symptom is evident, apply toner to the Transfer Belt again.
• If the Blade fails to remove toner completely off the Transfer Belt, perform step 11 once
again.
7. Place the remainder toner on the paper towel that
comes with the Transfer Belt Unit and apply an
even coat of toner on the Transfer Belt (up to 15
mm from both edges).
NOTE
• The toner, even if there is any remaining should
NOT be used in the copier. It is different from the
4025E031AA
Toner that is used in the Copier.
8. Holding onto both ends of the Transfer Belt,
rotate the Transfer Belt until the Blade of the
Transfer Cleaner Assy contacts the location on
the belt, to which the toner has been applied.
4025E032AA
9. Fit bosses (at the front and rear) of the Transfer
Cleaner Assy into the hooks (at the front and
rear) of the Transfer Belt Unit.
10. Secure the Transfer Cleaner Assy to the Transfer
Belt Unit using two screws.
4025E033AA
12. Insert the Image Transfer Belt Unit.
• Failure to have the Right side door open may result
in damage to the Transfer Belt or it Drive.
4025E052AA
E-21