6. Snap off one E-ring and remove the gear and pin.
NOTE
• Use care not to lose the pin.
7. Snap off one E-ring and remove the bushing.
8. Remove two screws and the Fusing Retraction
Position Sensor mounting bracket.
4004D125AA
9. Remove the gear (black).
4004D209AA
10. Remove two screws and the Fusing Pressure/
Retraction Motor.
4004D126AB
Precaution for Reinstallation
• When reinstalling the harness holder, make sure
that the protrusion on the backside of the holder
fits into the hole in the metal bracket.
4004D065AB
D-32