7. Wind the hook end of the cable around the pulley
NOTE
• Make sure that no part of the cable rides on the
4025D053AB
8. Slip the Cable Holding Jig onto the pulley to
4025D054AB
9. Install the front and rear pulleys and bushings
4025D056AA
10. Mount the Scanner drive gear on the shaft and
4025D057AA
0.1 mm
NOTE
• Allow a clearance of about 0.1 mm between the
4025D059AA
five turns counterclockwise, from the rear toward
the front side.
other.
secure the cable in position.
onto the shaft and fit the C-clip.
secure it using one screw.
Scanner drive gear and bushing.
D-25