Minolta CF2002 Service Manual page 272

Section Step
Image Adjust 10 After the Reset + Stabilizer
→
Stabilizer
→
Reset +
Stabilizer
(Tech. Rep.
Mode)
11 The problem has been elimi-
Check Item
sequence has been com-
pleted, run Gradation Adjust;
if the problem persists, make
adjustments of PRT Max
Density and PRT Highlight.
nated through the checks of
steps up to 10.
T-94
Result Action
NO Go to next step.
NO Change IU.
→
Change LPH Assy.
→
Change PIC Board.
→
Change LED Drive Board.
→
Change LPH Unit.
→
Change High Voltage Unit
(Developing Bias).
→
Change High Voltage Unit
(Image Transfer, Neutraliz-
ing).