Table 21: Verify Time - Bosch D9412GV3 Program Entry Manual

D9412GV3/D7412GV3 | Program Entry Guide | 2.0
When the detector senses smoke or fire, the area's
sensor reset relay interrupts power to points
connected to it for the time in Verify Time.

Table 21: Verify Time

Verification
Point Activation

Example: Total
Cycle time 80 sec
A# Duress Enable
Default: No
Selection:
Yes or No
Yes Enable Duress alarm for this area.
No Disable Duress alarm for this area.
Refer to Duress Type in Section 2.7 Miscellaneous
on page 36 for an explanation of duress.
For SIA CP-01 Compliance:
A# Duress Enable must be set to Yes.
The passcode you normally use for
duress is not valid in an area with A#
Duress Enable set to No.
If a passcode with the appropriate
L# Disarm authority is used to duress
disarm an area with A# Duress Enable
set to No, NO AUTHORITY appears in
the display. Also, if the keypad display is
moved to an area with A# Duress
Enable set to No using
[COMMAND][5][0], a valid duress disarm
passcode does not send a duress report.
Bosch Security Systems, Inc. | 10/11 | F01U170807-02
Panel and Area Wide Parameters
When power restores to the points, the 60-sec
confirmation window starts. If any detector, reset
during the verification time, experiences another alarm
during the confirmation window, an alarm occurs. If no
activity occurs during this period, no alarm occurs and
the verification window ends. If a Verification point
senses another alarm after the window ends, a new
verification cycle begins. Refer to Table 21 on page
39 for an example of Verify Time.
Verify Time/Reset
Sensors
Power removed,
ignore activity
20 sec
Get other manuals https://www.bkmanuals.com
To meet UL 864 requirements, set A#
Verify Time to 60 sec.
60 sec Confirmation Restart Alarm
Verification Cycle if
Generate alarm if
an Alarm Verification
additional activity
point activates.
received.
60 sec
EN | 39