Showing Details; Changing The Time For Resetting To Night Mode - Bosch FPA‑5000 User Manual

FPA-5000 | FPA-1200 | AVENAR panel 8000 |
AVENAR panel 2000 | AVENAR keypad 8000
2.
If the panel is in day mode, select Switch to night mode to switch to night mode.
Switching via the status bar
The panel is in night mode. To switch it to day mode:
4
4
The panel is in day mode. To switch it to night mode:
4
4
17.2

Showing details

It is possible both in day and night mode to display a list of all logical zones on the panel that
are currently switched to day mode.
To display a list of all detector groups in day mode
1.
2.
17.3

Changing the time for resetting to night mode

Caution!
After the system starts up following a power cut or battery failure, the default set back time
!
in FSP-5000-RPS is reset.
Notice!
Depending on the configuration, the set back time can be changed. It is only possible to make
a change for the current day. It is only possible to make a change if a specified time has
already been set for the current day in the programming software.
The set back time can be changed in day or night mode.
To change the time for resetting in night mode:
4
or
In the start menu, select Switch to day mode.
1.
Bosch Sicherheitssysteme GmbH
Confirm your selection with Switch to day mode.
The panel is switched to day mode.
To cancel the operation, select Cancel.
Press
or
Select Switch to day mode to confirm the request or Cancel to cancel the operation.
Press
Select Switch to night mode to confirm the selection or Cancel to cancel the operation.
In the start menu, select Switch to day mode or Switch to night mode, depending on
which mode the panel is currently in, or select the "day mode" or "night mode" icon on
the status bar.
Select Show details.
A list of all logical zones that are switched to day mode is displayed.
On the status bar, select
or
Select Change time.
User Guide
Day and night mode | en 73
2020-07 | 3.0 | F.01U.378.877