Displaying Tested Or Untested Elements; Assigning Tested Elements To A Walktest Group - Bosch MPC-xxxx-C Series User Manual

76 en | Maintenance – walktest
1.
2.
16.4

Displaying tested or untested elements

Notice!
You can choose to display either the untested or tested elements in the current walktest.
Select Exit from the status bar.
The following options are offered for the walktest currently being performed:
–
–
16.5

Assigning tested elements to a walktest group

Notice!
Only those elements in the current walktest that have been tested can be assigned to a
different walktest group.
On completion of the walktest, you can assign the tested elements to a different walktest
group (for the next walktest, for example):
1.
2.
2017.09 | 7.0 | F.01U.258.929
Select End from the status bar.
Various possibilities are offered on the display:
Select Yes in order to end the walktest for all walktest groups and elements. Select No to
cancel the operation and return to the previous display.
The walktest is ended for all walktest groups.
Select Not tested to display the elements that showed no reaction during the test or that
have not been tested.
Select Tested to display the elements that were tested and showed a reaction.
Select Exit from the status bar.
Various possibilities are offered on the display:
Select Assign tested elements to walktest group to assign the tested elements from the
current walk test to a walk test group for the next walk test:
A list of the walktest groups is displayed.
Select a walktest group from the list. Refer to Scrolling through lists, page 27 for
information on how to navigate through a list.
Two possibilities are offered on the display:
– Select Add to walktest group to assign the tested elements from the current walk
test to a selected walk test group.
– Select Overwrite walktest group to replace the elements in the selected walk test
group with the tested elements from the current walk test.
User Guide
Panel Controller
Bosch Sicherheitssysteme GmbH