Isolate; Menu Overview; Isolating And De-Isolating Elements; Displaying List Of All Isolated Elements - Bosch MPC-xxxx-C Series User Manual

Panel Controller
13

Isolate

This chapter contains information about the following points:
–
–
Caution!
Bypassed detectors: Alarm messages from bypassed detectors are no longer displayed, only
!
faults.
Isolated detectors: Isolated detectors are not analyzed.
13.1

Menu overview

Bypass -> Bypass
Block
Block
13.2

Isolating and de-isolating elements

Select the element you require in the submenu.
Example:
To isolate a detector, select the following in the start menu:
1.
2.
3.
4.
5.
6.
C
A C after a detector means that this detector is part of a closed group and cannot be isolated
individually. In order to isolate a detector marked in this way, please select Logical zone in
step 3.
13.3

Displaying list of all isolated elements

There are two ways to display a list of all isolated elements:
–
–
Bosch Sicherheitssysteme GmbH
Isolating and de-isolating elements, page 59
Displaying list of all isolated elements, page 59
Show blocked devices
-> Sounder
Transmission device
Logical zone
Bypass Block
Block
Detector
Various selection criteria are displayed. See also Working with lists, page 26.
Select a selection criterion, e.g. By description.
A list of the detectors is displayed. Refer to Scrolling through lists, page 27 for information
on how to scroll forward and backward through the list.
Select the required list fields.
The list fields are marked.
Select Block.
The selected elements are isolated.
To de-isolate the elements again, repeat all previous steps but select Un- block in step 6.
Using the menu, page 60
Via the status bar, page 60
Select by
number
Strobe
Detector
More...
User Guide
Block Group Printer
HVAC Doorholder
Extinguishing Annunciator
system
-> Control Interface
element module
2017.09 | 7.0 | F.01U.258.929
Isolate | en 59