Displaying And Un-Bypassing Bypassed Element Groups; Displaying List Of All Bypassed Elements; Using The Menu - Bosch MPC-xxxx-C Series User Manual

Panel Controller
6.
To remove the bypass from the elements, repeat all previous steps but select Un- bypass in
step 6.
Notice!
Depending on the configuration and the structure of the panel, it is possible that signaling
devices cannot be bypassed individually but only all at once. In this case, the NACAll list field
is offered in step 4 instead of the selection list.
12.3

Displaying and un-bypassing bypassed element groups

1.
2.
3.
4.
12.4

Displaying list of all bypassed elements

There are two ways to display a list of all bypassed elements:
–
–
12.4.1

Using the menu

To display a list of all bypassed elements, select the following in the start menu:
1.
2.
3.
4.
To un-bypass bypassed elements:
1.
2.
Bosch Sicherheitssysteme GmbH
Select Bypass.
The selected elements are bypassed.
In the Bypass field on the status bar, the number of bypassed elements is increased by
two elements.
There are two ways to display all partly or completely bypassed loops, logical zones etc.:
– Select Bypass on the status bar
A list of various states is displayed. Or
– Select Bypass Block in the start menu.
Select either Bypassed or Bypass and then Show bypassed devices.
A list of various element categories is displayed. The listed number displays the number
of bypassed elements or element groups in the relevant element category.
Select the list field you require, e.g. logical zone.
Select:
– Partly bypassed to display all partly bypassed logical zones
– Completely bypassed to display all completely bypassed logical zones
Depending on which option you select, all partly bypassed or fully bypassed logical zones
will be displayed. The number in parentheses, e.g. (5) specifies the number of bypassed
elements.
To remove the bypass from all elements in one or more logical zones, select the logical
zone you require and select Un- bypass.
Using the menu, page 57
Via the status bar, page 58
Bypass Block
Bypass
Show bypassed devices
A list of various element categories is displayed. The listed number displays the number
of bypassed elements or element groups in the relevant element category.
Select the element category you require, e.g. Detector .
A list of all bypassed detectors is displayed:
Select the element you require.
Select Un- bypass.
The element is un-bypassed.
User Guide
Bypass | en 57
2017.09 | 7.0 | F.01U.258.929