Bypass; Menu Overview; Bypassing And Un-Bypassing Elements; Displaying And Un-Bypassing Bypassed Element Groups - Bosch FPA‑5000 User Manual

50 en | Bypass
11

Bypass

This chapter contains information about the following points:
–
–
–
–
–
Warning!
All alarm and fault messages from bypassed detectors are no longer displayed.
!
11.1

Menu overview

Bypass -> Bypass
Block
Block
11.2

Bypassing and un-bypassing elements

Select the element you require in the submenu.
Notice!
Partly bypassed elements, such as loops or bypass groups, can be displayed and completely
bypassed; see Displaying and un-bypassing bypassed element groups, page 50 .
Notice!
The menu structure may be different depending on the configuration in FSP-5000-RPS.
Notice!
Depending on the configuration and the structure of the panel, it is possible that signaling
devices cannot be bypassed individually but only all at once. In this case, the NACAll list field
is offered instead of a selection list.
11.3

Displaying and un-bypassing bypassed element groups

1.
2.
2020-07 | 3.0 | F.01U.378.877
Bypassing and un-bypassing elements, page 50
Displaying and un-bypassing bypassed element groups, page 50
Displaying list of all bypassed elements, page 51
Bypassing/Un-bypassing buzzer, page 51
Bypassing/Un-bypassing the output to fault warning routing equipment, page 52
-> Show bypassed
devices
NAC
Detector
Bypass group
There are two ways to display all partly or completely bypassed loops, logical zones etc.:
– Select Bypass on the status bar
A list of various states is displayed. Or
– Select Bypass Block in the start menu.
Select either Bypassed or Bypass and then Show bypassed devices.
Select by
number
Transmission
device
Logical zone
More...
User Guide
FPA-5000 | FPA-1200 | AVENAR panel 8000 |
AVENAR panel 2000 | AVENAR keypad 8000
Bypass buzzer Printer
HVAC Doorholder
Extinguishing Annunciator
system
-> Control Interface
element module
Bosch Sicherheitssysteme GmbH