What's New In Version - Agilent Technologies InfiniiVision 2000 X-Series Programmer's Manual

1
What's New

What's New in Version 1.20

New features in version 1.20 of the InfiniiVision 2000 X- Series oscilloscope
software are:
• X cursor units that let you measure time (seconds), frequency (Hertz),
• Option for specifying FFT vertical units as V RMS as well as decibels.
• Option for saving the maximum number of waveform data points.
More detailed descriptions of the new and changed commands appear
below.
New Commands
Command
:FUNCtion[FFT]:VTYPe (see
:MARKer:XUNIts (see
:MARKer:XUNIts:USE (see
:MARKer:YUNIts (see
:MARKer:YUNIts:USE (see
:SAVE:WAVeform:LENGth:MAX (see
:TRIGger:FORCe (see
32
phase (degrees), and ratio (percent), and Y cursor units that let you
measure the channel units (base) or ratio (percent).
page
page 325)
page
page 330)
page
page 592)
Agilent InfiniiVision 2000 X-Series Oscilloscopes Programmer's Guide
Description
283) Specifies FFT vertical units as DECibel or
VRMS.
Specifies the units for X cursors.
326) Sets the current X1 and X2 cursor locations as
0 and 360 degrees if XUNIts is DEGRees or as 0
and 100 percent if XUNIts is PERCent.
Specifies the units for Y cursors.
331) Sets the current Y1 and Y2 cursor locations as
0 and 100 percent if YUNIts is PERCent.
page 442) Enable or disables saving the maximum
number of waveform data points.
Now documented, this command is equivalent
to the front panel [Force Trigger] key which
causes an acquisition to be captured even
though the trigger condition has not been met.