What's New In Version 2.20 - Agilent Technologies InfiniiVision 2000 X-Series Programmer's Manual

1
What's New

What's New in Version 2.20

New features in version 2.20 of the InfiniiVision 2000 X- Series oscilloscope
software are:
• Support for modulation of the waveform generator output.
• Support for controlling the optional DSOXDVM digital voltmeter analysis
• Ability to turn reference waveform locations on or off and view their
More detailed descriptions of the new and changed commands appear
below.
New Commands
Command
:DVM Commands (see
:WGEN:MODulation:AM:DEPTh (see
:WGEN:MODulation:AM:FREQuency (see
page
:WGEN:MODulation:FM:DEViation (see
page
:WGEN:MODulation:FM:FREQuency (see
page
:WGEN:MODulation:FSKey:FREQuency (see
page
:WGEN:MODulation:FSKey:RATE (see
page
:WGEN:MODulation:FUNCtion (see
:WGEN:MODulation:FUNCtion:RAMP:SYMMet
ry (see
:WGEN:MODulation:STATe (see
:WGEN:MODulation:TYPE (see
28
feature
status using the :VIEW, :BLANk, and :STATus commands.
page 263)
673)
674)
675)
676)
677)
page 679)
Agilent InfiniiVision 2000 X-Series Oscilloscopes Programmer's Guide
Description
Commands for controlling the optional
DSOXDVM digital voltmeter analysis feature.
page 672) Specifies the amount of amplitude modulation.
Specifies the frequency of the modulating
signal.
Specifies the frequency deviation from the
original carrier signal frequency.
Specifies the frequency of the modulating
signal.
Specifies the "hop frequency".
Specifies the rate at which the output
frequency "shifts".
page 678) Specifies the shape of the modulating signal.
Specifies the amount of time per cycle that the
ramp waveform is rising.
page 681) Enables or disables modulated waveform
generator output.
page 682) Selects the modulation type: Amplitude
Modulation (AM), Frequency Modulation (FM),
or Frequency-Shift Keying Modulation (FSK).